Print Page - How to reset the DCC smoke locomotive with EZ command

Title: How to reset the DCC smoke locomotive with EZ command
Post by: tps1978 on November 14, 2011, 09:41:58 AM

Hi

I have a DCC lay out with EZ command. I added a DCC smoke engine yesterday while playing with that it seems some how i end up corrupting the decoder of this new smoke engine from bachmann, is there any way i can reset the smoke engine to factory setting. I am new to DCC can any one help.

Title: Re: How to reset the DCC smoke locomotive with EZ command
Post by: Jim Banner on November 15, 2011, 12:40:29 PM

Unfortunately, the E-Z Command is unable to program CVs other than address and normal forward direction. It cannot access the CVs for resetting the decoder. Perhaps a friend, local hobby shop or local club can help you out.

Jim

Title: Re: How to reset the DCC smoke locomotive with EZ command
Post by: tps1978 on November 15, 2011, 12:52:53 PM

thanks jim

Bachmann Online Forum

Discussion Boards => HO => Topic started by: tps1978 on November 14, 2011, 09:41:58 AM