Hey Bach-Man: Bought an On30 reversing trolley set (brand new this year) for the Christmas layout. The car will work fine, back and forth, back and forth, for 6~10 X, then stop at one end. If I reverse the trolley on the track it then glitches at the opposite end. Followed the instructions in setting up the very specific track arrangement. A nudge gets it going again, but I would prefer it to run on it's own breakfast. It was set at the minimum stop delay. Any suggestions?
It sounds like on set of wheels is not getting good contact, try cleaning the track and wheels and also check that the pickup that contact the back side of the wheels are OK.
NM-Jeff
PS do you have another locomotive you can place on the track to verify your tack is OK? any Loco should work the same as the trolley
Thanks Back-Man :) I will give what you suggest a try. I do have a Hershey's trolley.
Not the Back-man or Bach-man but your welcomed let us know what happens
NM-Jeff