i have diesel engine to fast it's to fast to run with my anther diesel engine is there any way to slow it down ? ??? and to fast to pull car with out the cars flying off the tracks ::)
You have to learn to include more info in a question.
DC or DCC?
If DC, no easy way to match speeds.
Rich
dc right but soon it will dcc
Quote from: union pacific 844 on October 06, 2012, 04:05:20 PM
dc right but soon it will dcc
There is a learning curve. Just be patient. A lot will depend on the loco, decoder and DCC controller type.
Rich
844-
It also depends on the loco. If you have an older one with the notorious Hi-F drive,
all ahead flank emergency is the normal speed. But, really, any locomotive will go
more slowly if you cut back on the throttle.
-- D
My mistake. I thought he was trying to run two locos in consist.
Rich
Quote from: union pacific 844 on October 06, 2012, 01:10:29 PM
i have diesel engine to fast it's to fast to run with my anther diesel engine is there any way to slow it down ? ??? and to fast to pull car with out the cars flying off the tracks ::)
who makes them. Sometimes adding weight slows them down. Especially with Athearn phil
When you go into DCC, you can set the decoder to limit the top speed so the engine will run more the way you want it to. Until then, all you can do is keep the power down on your throttle.