Bachmann Online Forum

Discussion Boards => HO => Topic started by: chessyger on December 23, 2013, 01:09:04 PM

Title: H0 Alco 2-6-0 Steam DCC Ready open Tender?
Post by: chessyger on December 23, 2013, 01:09:04 PM
Hi
Sorry for my bad english
i am German
I have new a H0 Alco 2-6-0 Steam DCC Ready
I will built in a Sounddecoder.
I can not open the Tender for built in a speaker.
i can only open the coal load and see the PCB-Board and the 8 Pin Plug.
I found no Screws to open the complete Tender.
Can any help please

Juergen
Title: Re: H0 Alco 2-6-0 Steam DCC Ready open Tender?
Post by: Bucksco on December 23, 2013, 01:58:26 PM
There is a single screw in the center - front of the tender (you may need to sepearate the wires that run between the loco and tender to see it). Remove this screw and lift upward - there are two tabs that locate the tender body on the rear of the tender.
Title: Re: H0 Alco 2-6-0 Steam DCC Ready open Tender?
Post by: chessyger on December 23, 2013, 04:17:07 PM
Thank you
I found

Juergen