Bachmann Online Forum

Discussion Boards => HO => Topic started by: Spencer on April 09, 2014, 11:53:31 PM

Title: E-Z Track
Post by: Spencer on April 09, 2014, 11:53:31 PM
Hi Mr.Bachmann , I have recently purchased some 44132 and 44133 DCC E-Z Track turnouts , when fitting other track components i.e. 44511 straights , have found that the roadbeds, foul on the track beside it .. Question is do I have to trim the roadbed on both tracks , if so , by how much and at what angle is recommended ?
Title: Re: E-Z Track
Post by: Doneldon on April 10, 2014, 12:00:38 AM
Spencer-

Look at the undersides of the turnouts. You will see guide lines for removing roadbed areas so you can connect the diverging routes to other tracks.
                                        -- D
Title: Re: E-Z Track
Post by: Spencer on April 13, 2014, 04:13:26 PM
Thank you  , shortly after I sent this message , I inadvertently held one of the short sections of track supplied with the turnouts up to some light and found the cutout markings..
Stupid me...
Title: Re: E-Z Track
Post by: Morgun 30 on April 13, 2014, 04:58:44 PM
Quote from: Spencer on April 13, 2014, 04:13:26 PM
Thank you  , shortly after I sent this message , I inadvertently held one of the short sections of track supplied with the turnouts up to some light and found the cutout markings..
Stupid me...


No, just still learning