Hello folks -
My son got the Bachmann Easy DCC Command starter kit for christmas. When we plug the command center controller into the track - the number 1 button and the stop button flash rapidly. There is not any power to the train. Any ideas of where I can start to look for a solution? Thank you.
Did you follow the set up instructions exactly as stated in the manual?
Quote from: gdrucker1 on January 11, 2015, 02:09:17 PM
Hello folks -
My son got the Bachmann Easy DCC Command starter kit for christmas. When we plug the command center controller into the track - the number 1 button and the stop button flash rapidly. There is not any power to the train. Any ideas of where I can start to look for a solution? Thank you.
Try unplugging the wire that comes from the power suppy from the back of the command center, wait for 2 min and then plug it back in. See if that helps.
Read the manual, this is an indication of a dead short.