Text only | Text with Images

Bachmann Online Forum

Discussion Boards => HO => Topic started by: nrscroller on April 12, 2015, 06:50:18 PM

Title: Got my 44 tonner running and need program mode and cv values
Post by: nrscroller on April 12, 2015, 06:50:18 PM
Hi
I got my engine to work now in dcc mode with engine 03 program mode. I am using my 44 tonner on my little module and would  like to adjust vs values. What program mode do I use and where do I get a list of cv's and values for it.
Thanks
Bill
Title: Re: Got my 44 tonner running and need program mode and cv values
Post by: Hunt on April 12, 2015, 07:25:16 PM
If your locomotive has the Bachmann factory installed decoder  (DCC ON  BOARD)
Click Here  (http://www.bachmanntrains.com/home-usa/images/44913_Decoder_IS.pdf) for PDF of its supported CVs.


Are you using the Bachmann E-Z Command Control Center  to run and control it? If not what DCC system are you using?


   (http://shop.bachmanntrains.com/images/HO_Scale/44902.jpg)
             Bachmann E-Z Command Control Center
Text only | Text with Images