I have successfully programmed a Cobalt ADS-2fx to switch two pairs of points. I have tried to assign Hot Keys to both units but nothing seems to work. I am using a basic Dynamis Command and Control unit (no probox) and have followed the instructions to the letter in the user guide but to no avail. I have assumed rightly or wrongly that by pressing the appropriate hot key, say F1 that it would take me to the accessory address that I have allocated to that F key. The manual also suggests that you press shift F key. If I do that I get F11. does this mean that in fact there are 20 hot keys within the unit. Any help in solving this Hot Key problem would be much appreciated. DrJay
Make sure Dynamis is in accessory mode.
Many thanks for your reply. I think I've cracked it. DrJay