I just added more track to my lay out. When I went to start, the locomotive would not power up. When increasing the power, red light on the controller goes dim. I have checked all track connections. I also ran a voltage indicator over the track which showed power to the track. I don't have any extra accessories attached to the track. Is there something wrong with the locomotive. I am out of ideas. Any suggestions, would help. Thanks
apparently you have a short circuit. Can you post a drawing of how your track is laid out? I suspect that, not the locomotive, is the culprit.
Take the locomotive off of the track and then power up like when you did when the light went dim . If the light still goes dim just like with the engine on the track, the problem is the track. Yes, a track plan would help. You may have added a reversing loop which creates a short circuit without additional attention.