Print Page - E-Z Command Decoder: Setting Address using Digitrax Zephyr

Title: E-Z Command Decoder: Setting Address using Digitrax Zephyr
Post by: peteajr on January 21, 2009, 03:16:26 PM

Just purchased and installed an E-Z Command decoder (item 44915) but am unable to change the address from the default 03. Followed instructions in Zephyr manual but it just will not write a new address.
Any advice, insight?
Thanks

Title: Re: E-Z Command Decoder: Setting Address using Digitrax Zephyr
Post by: Hunt on January 21, 2009, 05:59:38 PM

Workaround required for CV read and programming a non-sound Bachmann decoder using a Digitrax Zephyr.

Workaround --- Place a 1000 Ohm, ¼ Watt resistor across the programming track. Remove the resistor after you finish programming the Bachmann decoder.

Title: Re: E-Z Command Decoder: Setting Address using Digitrax Zephyr
Post by: peteajr on January 22, 2009, 12:42:01 AM

Thanks! I'll give it a try

Bachmann Online Forum

Discussion Boards => HO => Topic started by: peteajr on January 21, 2009, 03:16:26 PM