I recently purchased a EZ Command DCC controller and one HO Bachmann DCC locomotive. I followed the instructions that came with it and I tried to change the address but could not get it to change. I tried it with another Bachmann DCC locomotive and had the same results.
Any suggestions?
Dear NM,
When you follow the directions, think "Control, Alt, Delete". Since the locos are on address 3, press the 3 button, and hold it down while you press stop. Release both at the same time. Then press the new address, and the loco should move a little to let you know its accepted the new address.
Have fun!
the Bach-man
NM
Did you figure it out yet?
You tube has a little video on how to do it. If i remember.
Let me know if you need the link
Robert