Print Page - using ez command turnouts with nce powercab system

Title: using ez command turnouts with nce powercab system
Post by: phranklyn on December 10, 2010, 08:14:23 AM

need help\info on how to use\program ez command dcc turnouts with nce powercab system. don't know jack about cv's. any step by step instructions appreciated. manufacturer's info(both) vague\unclear\confusing. Thanks!

Title: Re: using ez command turnouts with nce powercab system
Post by: Ezrails on March 15, 2019, 10:44:06 AM

I am having a similar problem. I purchased an EZ Track DCC equipped turnout to use in a demonstration/training layout, but I cannot get it to work with my NCE PowerCab. Any help is greatly appreciated as time is of the essence.

Title: Re: using ez command turnouts with nce powercab system
Post by: Len on March 15, 2019, 11:01:47 AM

These instructions may help:

https://tonystrains.com/news/programming-bachmann-dcc-turnouts-with-nce/

Note the 'caveat' mentioned here:

https://ncedcc.zendesk.com/hc/en-us/articles/201504015-Bachmann-E-Z-Command-decoder-equipped-Turnout

Len

Bachmann Online Forum

Discussion Boards => General Discussion => Topic started by: phranklyn on December 10, 2010, 08:14:23 AM