Text only | Text with Images

Bachmann Online Forum

Discussion Boards => General Discussion => Topic started by: bnsf06 on February 18, 2011, 05:58:36 PM

Title: DCC Loco w/sunami sound and decoder will not work w/ Dynamis wireless controller
Post by: bnsf06 on February 18, 2011, 05:58:36 PM
I have a Genesis  BNSF sd-70ace with sunami sound and digital decoder and cannot get it to work with my Dynamis wireless cotroller, I get absolutley nothing I figure maybe the code or address is not right.  It's being run on KATO  unitrack or bachman track I tried both and still nothing. What are my options, I only have a few feet of track connected does that matter?
Title: Re: DCC Loco w/sunami sound and decoder will not work w/ Dynamis wireless controller
Post by: bobwrgt on February 18, 2011, 06:04:28 PM
Do a reset to factory spec. That should reset the address. You can also try it on DC only to see if it runs.

Bob
Title: Re: DCC Loco w/sunami sound and decoder will not work w/ Dynamis wireless controller
Post by: bnsf06 on February 18, 2011, 06:15:37 PM
Factory reset on the loco or dynamis cotroller.  Also the command station is not lighting up like it did last night last night it was blinking orange and green, but now nothing? any sugestions
Text only | Text with Images