Bachmann Online Forum

Discussion Boards => Large => Topic started by: petertoot on July 18, 2011, 04:59:17 AM

Title: 3 truck shay,factory sound 82697
Post by: petertoot on July 18, 2011, 04:59:17 AM
hi there,will the sound in this loco work on track that is dc,as i run a te,to control track power,none of my locos are dcc,just track,thanks peter
Title: Re: 3 truck shay,factory sound 82697
Post by: Mike M on July 18, 2011, 09:15:51 AM
Pete it will work but you will only get the chuff You can not work whistle or bell and you can not adjust the vloume
Mike
Title: Re: 3 truck shay,factory sound 82697
Post by: Wade Colyer on July 18, 2011, 10:47:58 AM
Hi Peter:

MRC may have what you need.

http://www.modelrectifier.com/train-controls/dc-power-tech4.asp

Wade
Title: Re: 3 truck shay,factory sound 82697
Post by: tac on July 19, 2011, 07:35:34 AM
I have a QSI 'Quantum Engineer' analog device that operates all the sounds and effects by DC, rather than DCC, on my locos so fitted, from H0 right up to my Aristo Dash 9s.

It simply hooks up between the power source and the track, and is an economical way of operating DCC-equipped models with most of the effects.

Dunno if it might work for the Bachmann version of DCC, which, I'm told, us somewhat different, but it works on fourteen of my locos.

tac
www.ovgrs.org   
Title: Re: 3 truck shay,factory sound 82697
Post by: petertoot on July 19, 2011, 08:17:54 AM
HI,thanks for the replys,maybe if i used batterys,and the right decoder,then i need a control for that,or go to the newer,dare i say aristo te,all a bit confusing,as i have a lot of locos,12,approx,any ideas are welcome,again,thanks,pete
Title: Re: 3 truck shay,factory sound 82697
Post by: Loco Bill Canelos on July 19, 2011, 09:18:30 AM
Pete,
There are many nice control systems, and Kevin Strong did a great series on them in Garden Railways magazine awhile back.  maybe he will chime in and mention which issues.

Since you mentioned TE, I use the latest TE 2.4 Gig Revolution I too have 12 locos.   I bought two transmitters which came with receivers, Then I bought two six packs of receivers.   The six packs work out to about $65 per loco.  With two transmitters I felt that if one were to be dropped or broken I would have a spare.  I love the visual interface and the individual control of bell whistle, coupler clank and so on.  I very much like the multiple unit capability and ease of programming.  It has great range as well.   Even tho it was expensive,I am glad I put a receiver in each loco, because I do not like having it in a battery car trailing behind the loco all the time.   You can save a lot of money using a battery car or two battery cars, and just attach whatever loco you want to run.  There are so many ways to do things in this hobby, it can be hard to choose.  Maybe other will mention their control systems, if not check out Kevins articles!!   Since I do not have any Bachmann Locos with factory sound, I cannot say how the Aristo Revolution works with them. I use other brands of sound with no problems.

Bill


Title: Re: 3 truck shay,factory sound 82697
Post by: Sleeping Bear on July 19, 2011, 11:12:38 AM
  While I am still in the collecting up stuff stage, I have been looking into control systems and have taken a liking to QSI Quantum Aristo for my PnP locos and the Quantum Magnum for my non PnP units. I also plan for on board batteries so each loco can run solo if needed. The QSI G wire control unit can be programed for single as well as multi unit consits and even though the instructions can seem a little confusing at first glimpse, I have hunted around and found straight forward explanations. If you read the instructions carefully, slowly, and two or three times as I had to.. its not that difficult to program any of this. Wiring a non PnP unit is going to be easy as well since I got out of my own way.  As Bill said, there are many systems out there, do some searching and reading and pick the one that's right for you. There is no wrong answer that way and only you can pick whats right for you.    Later all......S.B.
Title: Re: 3 truck shay,factory sound 82697
Post by: petertoot on July 20, 2011, 05:13:58 AM
hi guys,many thanks for the infi,by the way,i was not putting down aristo produts,as i have 2 te,but i know bachmann is not as sensitve to a remark about another maker,unlike the other maker,enough said,i have locos,etc from all makers all are good value,but bmanns locos have more detail,spectrum is xcellent,i will do some research,again thanks,ps,any one have a heisler for sale,the only one i havent got yet,cheers from ozzie ;D ;D ;D