Bachmann Online Forum

Discussion Boards => General Discussion => Topic started by: swllisranch on August 04, 2011, 06:45:16 PM

Title: n scale radius e z track
Post by: swllisranch on August 04, 2011, 06:45:16 PM
What radius track degrees will run parallel to obtain an inner and outer loop?
Title: Re: n scale radius e z track
Post by: NarrowMinded on August 04, 2011, 07:53:51 PM
You should post this in N scale,

I'm not up on what radius are offered in N scale EZ track, I see they make a 19" radius and a 17.5" radius, these would be good for an inside and outside loop.

The degree's are how many degree the track points to if you start from zero degree's

if you had a single one piece circle it would be a 360° if you had two pieces thatformed a circle they would be 180°  4 would be 90° if it takes 12 to make a full circle they are 30°

Hope this helps

NM-Jeff