Print Page - EZ Command starter engine problem

Title: EZ Command starter engine problem
Post by: rrman on October 04, 2011, 09:41:41 PM

I bought the EZ command dcc set and a few days later the chessie system engine that came with it stopped moving. The headlight still works but the engine wont move forward or backwards. please help.

Title: Re: EZ Command starter engine problem
Post by: NarrowMinded on October 04, 2011, 11:25:32 PM

Make sure you have location 3 selected (Default on the loco from the factory) try turning the light on and off, if it responds but still wont move, let us know if not try another address and do the same.

if it does go on and off but wont move let us know so we can try some other things.

You can test the Loco on a standard DC layout as well they are set to run on DC from the factory as well. let us know what happens.

NM-Jeff

Title: Re: EZ Command starter engine problem
Post by: rrman on October 05, 2011, 08:38:16 AM

I tried running it on dc power and it still doesnt move forwards or backwards

Title: Re: EZ Command starter engine problem
Post by: NarrowMinded on October 05, 2011, 05:21:31 PM

I just remebered I had the same problem with a Rail truck last year, and had to reset it to factory defaults to get it to run again.

NM-Jeff

Title: Re: EZ Command starter engine problem
Post by: rrman on October 05, 2011, 05:25:57 PM

thanks

Bachmann Online Forum

Discussion Boards => General Discussion => Topic started by: rrman on October 04, 2011, 09:41:41 PM