Bachmann Message Board

Discussion Boards => General Discussion => Topic started by: firetrain on August 21, 2013, 01:48:15 PM



Title: How to remove the shell on a EMD GP40
Post by: firetrain on August 21, 2013, 01:48:15 PM
Can some help me out? I'm trying to take the shell of a EMD GP 40 locomotive to make it a dummy and need help?


Title: Re: How to remove the shell on a EMD GP40
Post by: richg on August 21, 2013, 04:06:29 PM
To my knowledge, you remove the couplers if this is a HO scale.

You probably did not pay attention, there are forums for different scales.

Rich


Title: Re: How to remove the shell on a EMD GP40
Post by: Jerrys HO on August 21, 2013, 06:06:33 PM
Pry the fuel tank off and you will find 4 screws underneath, remove them and pull the shell straight up.
The only ones I know of Rich that you have to remove the couplers are the SD's unless the older versions of GP's were different.

Jerry


Title: Re: How to remove the shell on a EMD GP40
Post by: richg on August 21, 2013, 06:55:41 PM
Yeah, I was not quite sure but I have bookmarked the page.

Rich