Bachmann Online Forum

Discussion Boards => Williams by Bachmann => Topic started by: kountry mailman on April 09, 2015, 08:09:57 PM

Title: Crown Edition GG1 problem
Post by: kountry mailman on April 09, 2015, 08:09:57 PM
I have an older Williams GG1 powered and dummy with sound.  It will say the start-up sounds and the horn will blow when button pressed, BUT while in motion the horn will start blowing a lot of the time and pressing any button will not make it stop.  You have to kill the power to make it stop and soon after restarting the horn blows again.  I tried cleaning wheels and  power pick-up roller.  Removed shell and can't find anything  loose around the board.  Any suggestions or thoughts would be greatly appreciated  PRR fan in central PA
Title: Re: Crown Edition GG1 problem
Post by: Joe Satnik on April 09, 2015, 09:51:28 PM
Dear MM,

Make and model of your transformer, please?

Thanks.

Joe Satnik
Title: Re: Crown Edition GG1 problem
Post by: phillyreading on April 10, 2015, 07:03:26 AM
Have you cleaned the track as well?
I had a Williams S-2 Pennsy steam engine and tender do the same thing except I had just a basic transformer, no whistle or bell feature, when it happened. My solution was cleaning the track and wheels of the tender.
Do your GG-1's have a tether between the units? If so you may have to clean the wheels on both powered and unpowered engines.

Lee F.
Title: Re: Crown Edition GG1 problem
Post by: kountry mailman on April 10, 2015, 05:10:06 PM
My two units are not connected to each other and I am powering them with a MTH 1000 watt transformer on Fas Track.  All other engines work O K, all in conventional mode.  I don't have DCS or TMCC, Thanks for any suggestions,  I think that I have noticed that when the unit runs across an un-coupler track section or an insulated rail jointer is when the horn starts to blow.  Like it is related to a momentary break in power to the center rail pickup roller.  I will have to explore that option a little further
Title: Re: Crown Edition GG1 problem
Post by: Joe Satnik on April 10, 2015, 09:33:47 PM
Dear MM,

Do you mean the 100 Watt  Z1000 ?

http://www.ebay.com/itm/MTH-40-1000-Z-1000-Transformer-with-100-Watts-of-Power-/301528242623?pt=LH_DefaultDomain_0&hash=item46347bd9bf

As far as I can tell, that has a chopped sine wave output, which may be confusing your loco's sound triggers. 

Try a pure sine wave output transformer and see how your loco reacts.

Any postwar transformer should have pure sine wave outputs. I use an old 1033.   

Hope this helps.

Sincerely,

Joe Satnik
Title: Re: Crown Edition GG1 problem
Post by: TrainmanGene on April 20, 2015, 05:04:22 PM
If it's a True Blast 1, I had the same problem and replaced it with a True Blast 2.