Bachmann Online Forum

Discussion Boards => General Discussion => Topic started by: cwex on January 09, 2017, 07:42:21 PM

Title: Width of table to accommodate a 26 inch curve track
Post by: cwex on January 09, 2017, 07:42:21 PM
What is width of table I need to have 2 ovals , one with 22 inch radius and the other loop with 26 inch radius curve,
Title: Re: Width of table to accommodate a 26 inch curve track
Post by: tiebreaker on January 09, 2017, 07:48:52 PM
I would go no less than 5 ft.  to leave a little on the sides, without measuring mine I can not give an accurate measurement but if needed I can post later.
Title: Re: Width of table to accommodate a 26 inch curve track
Post by: cwex on January 09, 2017, 07:51:55 PM
Thanx. I can go wider than 5 feet if you have exact measurement. Would you recommend 6 feet.
Title: Re: Width of table to accommodate a 26 inch curve track
Post by: tiebreaker on January 09, 2017, 07:58:25 PM
I have 26 and 28 radius in the 5ft and it leaves approx. 2 inches maybe a little more on both sides of the 28.
If your not going any bigger 5ft. will leave more than enough room.
Title: Re: Width of table to accommodate a 26 inch curve track
Post by: cwex on January 09, 2017, 07:59:57 PM
Thank you
Title: Re: Width of table to accommodate a 26 inch curve track
Post by: tiebreaker on January 09, 2017, 08:03:34 PM
Your welcome
Title: Re: Width of table to accommodate a 26 inch curve track
Post by: tiebreaker on January 09, 2017, 10:17:31 PM
Had time to measure when I got home and from side to side (including roadbed, not center to center) is 54". Thls leaves 3" on each side.