Print Page - ez command interconnecting wire

Title: ez command interconnecting wire
Post by: pjletizia on June 11, 2017, 11:21:20 AM

I have misplaced the black interconnecting wire to connect ez command to a Bachmann DC power pack. Does anyone have one they never will use? I would like to buy it from you.
Thanks
Pete

Title: Re: ez command interconnecting wire
Post by: Len on June 12, 2017, 09:23:10 AM

You should be able to use a stereo (tip/ring/sleeve) mini-plug to mini-plug cable from the electronics section of most department stores. Make sure it has stereo plugs, mono (tip/sleeve) plugs will cause a short.

Len

Title: Re: ez command interconnecting wire
Post by: pjletizia on June 12, 2017, 10:13:26 AM

Thanks for the quick response. Another question then. What is the I/O port for on the back
of the EZ Command Console used for?
Thanks
Pete

Title: Re: ez command interconnecting wire
Post by: Len on June 12, 2017, 11:50:55 AM

About the only thing I can think of that plugged into the I/O port was the 'EZ-Command Companion'.
https://www.modeltrainstuff.com/Bachmann-EZ-Command-Walk-Around-Companion-p/bac-44907.htm

I don't think they're being produced any more.

Len

Bachmann Online Forum

Discussion Boards => General Discussion => Topic started by: pjletizia on June 11, 2017, 11:21:20 AM