Text only | Text with Images

Bachmann Online Forum

Discussion Boards => General Discussion => Topic started by: custerg911 on January 29, 2018, 09:34:54 PM

Title: Can EZ Command be programmed to be used with MRC 1628 decoder?
Post by: custerg911 on January 29, 2018, 09:34:54 PM
Have seen MRC 1628 (4 solenoid) decoder board programmed with NCE and MRC systems to run this decoder. Can EZ Command system also be used if addresses are 1-8. Have 6 turnouts?

Curt Doduff44
Title: Re: Can EZ Command be programmed to be used with MRC 1628 decoder?
Post by: Hunt on January 31, 2018, 07:48:27 PM
A MRC 1628 stationary accessory decoder cannot be used with an E-Z Command Control Center, item 44902.
Title: Re: Can EZ Command be programmed to be used with MRC 1628 decoder?
Post by: custerg911 on January 31, 2018, 09:13:33 PM
Thanks for reply. Was hoping but know limited capability of EZ Commend system.
Text only | Text with Images