I'm trying to program this engine with a long 4 digital address
I put it on the program track and programmed cv29. I then confirmed it with a read.
Values I trI'd are 32 36 38 and 34
When I stick it on the main track it only responds to short address.
I know it's reading cv29 because I I set a value of 1 or 255 the Loco runs backwards as it should
You might find this page useful for making sure you're inputing the correct values to CV29 and CV17/18:
http://www.2mm.org.uk/articles/cv29%20calculator.htm
Len
What is being used to program?
A 1000 Ohm, ΒΌ Watt resistor laid across the programming track is required for programming a factory installed non-sound Bachmann (Lenz based) decoder used with a Digitrax Zephyr (DCS50) or Zephyr Xtra (DCS51).
Remove resistor after programming.