Print Page - Info on FT with decoder #H601x-PC801

Title: Info on FT with decoder #H601x-PC801
Post by: StanW on April 09, 2008, 03:52:49 PM

Need info on above decoder

Title: Re: Info on FT with decoder #H601x-PC801
Post by: the Bach-man on April 09, 2008, 11:58:06 PM

Dear Stan,
The decoder is built into the circuit board. It is dual mode, so the loco will run on analog power.
Have fun!
the Bach-man

Title: Re: Info on FT with decoder #H601x-PC801
Post by: StanW on April 16, 2008, 02:05:41 PM

Thanks for the info

My problem is that decoder pro is not seeing the decorder to program it. Any ideas.

Thanks Stan

Title: Re: Info on FT with decoder #H601x-PC801
Post by: Hunt on April 16, 2008, 03:35:53 PM

Quote from: StanW on April 16, 2008, 02:05:41 PM
Thanks for the info

My problem is that decoder pro is not seeing the decorder to program it. Any ideas.

Thanks Stan

Using Decoder Pro with a Digitrax Zephyr?
Then a workaround is required to program a non-sound Bachmann decoder using a Digitrax Zephyr.

Workaround --- Place a 1000 Ohm resistor across the programming track. Remove the resistor after you finish programming the Bachmann decoder.

Bachmann Online Forum

Discussion Boards => HO => Topic started by: StanW on April 09, 2008, 03:52:49 PM