Print Page - Brill trolley shell removal

Title: Brill trolley shell removal
Post by: Paul M. on March 06, 2007, 09:40:56 PM

Does anybody know how to remove the shell of the brill trolley? I tried a little bit, but I didn't want to mess things up. I need to re-paint the trolley for my own "Emhurst Interurban" line . Any help will be appreciated. ;D

Title: Re: Brill trolley shell removal
Post by: Paul M. on March 08, 2007, 11:32:28 AM

bump

Title: Re: Brill trolley shell removal
Post by: Paul M. on March 09, 2007, 11:36:31 AM

Anyone?

Title: Re: Brill trolley shell removal
Post by: Jim Banner on March 10, 2007, 05:20:06 PM

Paul, I have hesitated to reply because I am not absolutely sure that the H0 trolley that our group has was made by Bachmann. With it, you gently pry one side of the body away from the frame, both near the front and near the back, then pull the frame down a bit. Then you do the same with the other side. The frame has four small tabs (2 on each side) that fit into slots in the body.

I hope this helps.

Title: Re: Brill trolley shell removal
Post by: Jonathan MacCormack on March 10, 2007, 08:21:12 PM

Jim,

FYI

Page 53, 2007 catalog, Brill Trolley. Just in case you missed it while browsing. It may not be what your goup has on the layout.

Jonathan

Title: Re: Brill trolley shell removal
Post by: Paul M. on March 10, 2007, 09:19:59 PM

Thanks, Jim. I'll try certainly try it.

Bachmann Online Forum

Discussion Boards => General Discussion => Topic started by: Paul M. on March 06, 2007, 09:40:56 PM