Print Page - EZ-command question about steps

Title: EZ-command question about steps
Post by: tiz on February 18, 2009, 01:50:06 PM

Hello!
Recently I bought EZ-Command with 2 Bachmann DCC decoders ( default 28 steps on speed). I have one decoder from Hornby, programmed at 128 speed steps. For EZ, in manual says 28/128 steps. Does it mean that it can run both 28 and 128 steps decoders or I have to change CV on Hornby?
Thank you in advance and Regards to all members!

Zdenko, Toronto

Title: Re: EZ-command question about steps
Post by: the Bach-man on February 18, 2009, 10:26:38 PM

Dear Zdenko,
It should work fine with no change.
Have fun!
the Bach-man

Title: Re: EZ-command question about steps
Post by: tiz on February 19, 2009, 08:12:37 AM

Dear Bach-man,

Thank you very much for the fast answer!

Best Regards

Zdenko

Bachmann Online Forum

Discussion Boards => General Discussion => Topic started by: tiz on February 18, 2009, 01:50:06 PM