News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - redchuckb

#1
General Discussion / Re: programming problems
November 07, 2011, 06:37:25 PM
Thanks.I appreciate the info.
#2
General Discussion / programming problems
November 04, 2011, 05:29:34 PM
I am new here,but here goes.I have 6 engines programmed on my EZ Command controller.It has been approx. 8 months since i have done anything with the set.Now i have cleaned and re-started,i can only get two of the 6 to work properly.Two of the engines will run on address 3,they just run backwards to the direction arrows.Two are working great and two i havent tried yet.Any suggestions on how to fix the two that are running backwards?The same two wont take a re-program either.I have tried that several times and they act like they are not receiveing the instructions.They respond to speed knob but only on address 3,and then,as i said,they run oppasite to the direction arrows.Any help or suggestions will be helpful.Thanks,Charlie