News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - edahlum

#1
General Discussion / Brill Trolley and DCC
May 05, 2016, 09:57:05 AM
Dear Bachmann,
I am looking to add DCC to my new Brill Trolley.
When I opened up the Trolley there is a PCB board - H610+PCB01. The light and motor are connected to it. What is it for? When I tested it the same voltage that goes in the board from the pick ups goes out to the light and motor. I can not figure what the board is there for?
Lastly, should I remove the capacitor across the motor leads?
Thanks!
#2
HO / Bachmann Brill Trolley
May 03, 2016, 12:55:34 PM
Dear Bachmann,
I am looking to add DCC to my new Brill Trolley.
There is a PCB board - H610+PCB01. The light and motor are connected to it..
First what is it for? The same voltage that goes in from the pick ups seems to go out to the light and motor. I can not figure what it is there for?
Also, when I install a DCC should I keep it in line between the DCC and the motor or remove it and go directly to the motor from the DCC?
Lastly, should I remove the capacitor across the motor leads or remove it?
Thanks, Ed.