News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - taycotrains

#1
HO / Resetting to 3
December 01, 2008, 10:29:21 PM
Another problem...

I have a GE 70 Tonner that was purchased used.

The engine runs fine on a analog track,but does not respond to any
address on the EZ commander.
Is it possible someone assigned it to address on another dcc set up the the EZ Commander does not recognize ?

Is it possible to reset to factory address #3.

Thanks
Bob
#2
HO / EZ command question ?
November 30, 2008, 05:43:30 PM
I lost the CD that came with the original set.
I have more DCC engines than addresses now.
What is the procedure for assigning 2 engines to the same address
tail to tail ?
Thanks Bob