Greetings all...
I need help reassembling the boiler of a Spectrum 2-8-0. If I get the washers aligned to attach the screws and chassis connectors, the spacers on the bottom of the boiler either move or fall out of place. If I get the bottom of the boiler aligned, the top is too wide to accommodate the chassis connectors and screws. If I am fortunate enough to get the boiler alinged, it's difficult to get the cover over the motor assembly without everything coming apart and keeping the motor in place with the belt drive.
I know I can use a drop of glue to secure the washers and spacers until I get the screws in place, but, that doesn't resolve the alignment issues so everything fits as it should.
This has been a frustrating task. I would prefer to keep the engine running and not make it a display model.
I truly appreciate your help and suggestions! Thank you in advance!
I need help reassembling the boiler of a Spectrum 2-8-0. If I get the washers aligned to attach the screws and chassis connectors, the spacers on the bottom of the boiler either move or fall out of place. If I get the bottom of the boiler aligned, the top is too wide to accommodate the chassis connectors and screws. If I am fortunate enough to get the boiler alinged, it's difficult to get the cover over the motor assembly without everything coming apart and keeping the motor in place with the belt drive.
I know I can use a drop of glue to secure the washers and spacers until I get the screws in place, but, that doesn't resolve the alignment issues so everything fits as it should.
This has been a frustrating task. I would prefer to keep the engine running and not make it a display model.
I truly appreciate your help and suggestions! Thank you in advance!