Hi all.
I recently switched from HO to N scale and one of my first purchases was this non-sound model with DCC On Board. I'm very pleased with its operation, but here's the conundrum:
I can't re-program the loco's address from the factory '003' to the engine's number (6910). Nor can I 'read' the address - that 'd_nd' error keeps coming up. I have a Broadway Limited decoder-equipped E8A (with sound) and had no problem reading and changing the address but I'm at a loss to figure out why I can't do the same with the Centennial.
I'm using a Digitrax Zephyr system with a stand-alone programming track. It's been suggested that I purchase an add-on booster for my programming track (ie. a Digitrax PR3) because the Zephyr system doesn't have enough voltage.
Any help would be appreciated.
I recently switched from HO to N scale and one of my first purchases was this non-sound model with DCC On Board. I'm very pleased with its operation, but here's the conundrum:
I can't re-program the loco's address from the factory '003' to the engine's number (6910). Nor can I 'read' the address - that 'd_nd' error keeps coming up. I have a Broadway Limited decoder-equipped E8A (with sound) and had no problem reading and changing the address but I'm at a loss to figure out why I can't do the same with the Centennial.
I'm using a Digitrax Zephyr system with a stand-alone programming track. It's been suggested that I purchase an add-on booster for my programming track (ie. a Digitrax PR3) because the Zephyr system doesn't have enough voltage.
Any help would be appreciated.