fta: under the trucks, there are two screws each that you need to take off and there are two on the fuel tank that you dont nessisarily need to take off

i have 6 passenger cars and they handel fine on both types of turns
a little trouble in my tunnel but they fair well

i pull it with my sante fe not all at once of course

i have a dummy either ftb or f7b, 6 passenger cars (varying), 5 boxcars (varying but one coupler broke on one of them so 4), a bat signal car and a caboose

well for then i will have to go to colorado springs

is hobby lobby a good hobby shop

i need to find some suplies for my trains and wnat to know is it cheaper to go to a store or buy online

does anyone know where i can get turnouts and turntables kinda cheap (for ez track too)

i have a batman train and was wondering does anyone else have one

ok is it the same with turntables

Quote from: jward on February 07, 2011, 07:57:30 PM
add an incline up to a second level of track. maybe a bridge or two over the lower level, and a couple of spur tracks to some factories. then start delivering cars to all those factories, and pulling loaded cars. send the loaded cars to other factories on your line. in other words, get away from just watching your trains chase themselves around an oval. that gets boring really quick. give your railroad a purpose......

the problem here is im stuck with a batman train and i dont have the stuff to go onto my table it is so small too i can avoid the train chasing itself by running into my bumpers

well that helped on some of them but ones like #6 turnout and that are confusing

all these train terms are driving me nuts can someone tell them to me

just like ideas to upgrade my layout because im bored with it right now

i have a two track yard and one track that goes right through (not mainline) and on my mainline i have a station and a stub ended siding along with a passing siding and a tunnel (aka my old thomas table)