about one foot

hello can anyone tell me where the most common points on a steam engine that get dirt are?

this should help...

is there a n-scale three truck shay in the works with dcc?

k thanks know i can finally put some pictures in.

i hear ya there

it still will not let me put photos on even though i have photobucket.

thanks now it runs flawlessly.

basicly all i did was removed the bottom part holding the wheels in and put the spring on the small rod that the front truck goes on then i would test the engine to see if the drivers where sitting on the rails if they were not i would cut the spring smaller and try againg until the drivers sat securely on the rails.

what is the manufacturer and where can i find one?

my sd-40-2 (from kato) will sit but will not run i have a dcc decoder in it ti used to run but know it will have only lights and won't run forward or reverse can anyone give me a reason and cure for this

hi i have noticed photos in the text part of peoples messages i would like to know how. if anyone knows can you please tell me?

i am curious to know how many others are out there wanting to see an Alleheny on the market. if so please reply.

they do run way better in dcc and some times the decoder becomes glitchy and won't run too well in comparison to an engine always run on dcc.

where are the wheels coming loose? on the sides or the bottom?