That must make it a little easier to clean up the mess! I never knew that was possible!

Phil

Here's the scoup-

I had the problem on the old forum. Where do you put the bell, and where does the doghouse go? There are no holes for either!?

What I found out is that you have to put the holes in yourself. On the faceplate, there is a indentation on the top. Take a X-Acto knife, and cut it out. That is where the bell goes. If you want the other bell, you'll have to take off the shell, and punch a hole through.

If you want the doghouse, you'll have to take the tender shell off, and punch the holes in (They are indented also).

I agree, that Bachmann should include a special sheet for the Undec engine, and where to put the bells, ect in.

Hope this helps. It is a good engine.

Phil

Hey Bach-Mann-

What is the prototype for the Excursion Cars? Cass? D&S? Freelance?

Phil