It is a  Brill. I have plenty of old flex track left over from my old layout. Now, I am planning a portable layout to go into a guitar carry case. My intent was to spend a minimum on track (read that as 'no $$$') and jut have a little fun at train shows. I saw a photo of one and it struck a chord.

You can check out my old N-Scale layout at my personal site: http://wpporter.duckburg.us/ if you have nothing better to do.

Bill

  Yes indeed, the Brill trolley navigates the 7-inch circle just fine - both directions and both orientations. I am pretty sure it would handle tighter radii as well. The nearly new trolley arrived and worked. I cleaned a little lint out and added a small amount of lubrication to help it work even better.

I have not tried a PCC style trolley.

Bill

UPDATE: I made a small loop of Atlas flex track. It is a circle with radius 7 inches. On this loop, I have successfully run an older RS-3. Such a loco is longer than the trolley chassis from Bachmann. Next up, I will try a Bachmann Brill trolley on the loop.
Bill

OK. Thanks. I suspect I will just have to get one or two and try them. I was expecting the radius to be in the 6 or 7 inch range considering the short length and independent trucks. Do you know if the Brill or the PCC style handles shorter radii?

Hi Folks, I am planning a specialized portable layout. I need to know the minimum radius that the Brill and PCC cars can handle. Usually that sort of info is part of the product description. I recall an Athearn switcher in the 1950's that ran on a track with a silver dollar as the inside rail. So, What is the minimum radius for Brill and PCC trolleys?
Thanks, Bill