News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - chitty

#1
HO / Re: How do I wire up a ho switch ?
September 28, 2011, 09:20:41 AM
The picture that you sent was accurate and your discretion sound right! Awaiting your instructions.


              Thanks!
#2
HO / Re: How do I wire up a ho switch ?
September 27, 2011, 08:49:22 AM
Jim- I am using a Bachmann switch that is DCC. The trouble is that a engine does not pass through the switch it stalls. The second switch is fine now.


Sorry, but so far I can't figure out how to draw!  My layout is simple,  it is a circle with a crossing across it at the half way point. I think that a have isolated down to a switch. After removing the switch and power-up the switch the problem is still their. I have run the switch with the frog powered and without.
#3
HO / How do I wire up a ho switch ?
September 25, 2011, 03:44:09 PM
I have a simple set-up where I have two switches.  The problem I have is
a simple short circuit accross the power lines. I have placed plastic spacers on the ends of the swiches but no avail. The switches are placed where activition of one causes a short in the other. Thank you for your help.