News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Peter1952

#1
I haven't used the EZ Command for a number of years, but I think it reverts to position 1 after a short. Is it only happening with locomotives with a long wheelbase, or with only 1 locomotive.
#2
Hi Marty,

Unfortunately CV5 is not available on the Bachmann Decoders.

:(Peter :(
#3
N / Re: sd-40-2
February 19, 2012, 03:01:47 AM
Sounds like your decoder is not making contact with the motor. If it is a drop in lightboard replacement the motor contacts can sometimes look like they are making contact, but are not. Bend them in carefully to make sure there is contact. If it is hard wired, check the solder joints on the Orange and grey wires. In both cases make sure there are no shorts.
Good luck, Peter.