Rich,
I cut the LED's from the board and picked up some 1/4 watt 1K resistors and installed just like you said - worked fine.  Thanks so much for your help.  Now I can install LED's in the rest of my loco's

Hueydr (Vic)

Rich, I have taken some pictures for you to see the LED's on the board. I know how to hookup the motor wires and rail wires, just need to know what I should do about the LED's (where to solder the white, yellow and blue from the decoder.
Thanks again for your help.

Vic

The Bachmann B23-7 comes with front and rear LED lights on a long circuit board H11105, (PCB with light bulbs and diodes).  My question is were to connect the white, yellow and blue wires to controll the lights? Do I have to ditch these lights and buy new LED lights with resistor?

Thanks ahead of time if anyone can help me.

Hueydr

thanks very much
vic

Can someone tell the use of the I/O port on the control center?  Can it be used with a laptop?

Thanks ahead of time.

Vic