Thanks for your response. I will have to study and see how this would work.

Duke

I have the 44211 Power Controller. I want to power the switch controllers that comes with the Remote Turnouts 44561 and 44562. Since the Power Controller does not have an accessory port can I power the switch controllers from the track power cord plug in? Yes, I do know that the Power Controller is 16 VDC.

My grandson's DCC EZ Command Plus controller has also stopped working. Lights come on but nothing happens. Engine does not light up or move or have sound. Worked fine a few days ago. In DC mode, engine lights up and motor revs up but still no movement. I will try changing out the red power wire. Any other suggestions?

Thanks so much for the info!!! 

Greetings,
  I just bought the HO GS4 American Freedom Train for grandson but only has DCC instructions. He also has the HO GS4 Daylight Special with user instructions. Question is: does the DCC American Freedom Train have a smoke generator?
  Additionally, are Daylight instructions applicable for both models?

Regards,
The Duke

Good luck Steve!!
Duke

Never looked at it that way. I have both poles up since no way to raise and lower the poles when direction changed. And besides if auto reverse than not enough time between next run start to lower one or the other pole.

You are welcome!
My layout is set in 50's-60's era so I am using some old style brown poles that have the catenary wire arms so I have the poles in up position like they are active when running.

From the bottom of the wheels to top of room is 1" and from bottom of wheels to top of the cable arm is 1 1/2". Be advised that the Hayes bumper is not where the trolley actually stops; but further up because the B sections are not powered.

Greetings,
  With the Auto Reverse track can the 2 5" 'B' sections be replaced with the 2 5" 'A - B' sections so that the Brill Trolley will stop closer to the Hayes Bumpers? This would allow me to have longer runs than if the Trolley stopped before the 'B' track.

Regards,
The Duke

I bought the Bachman N motorized turntable and it works well. However, the tracks will not line up with the Walthers roundhouse. Is there a transition track I can use from Bachman to another track? My thought is to buy another turntable that will work with the roundhouse. Basically - an engine comes off the EZ track and transitions to the other turntable track which engine in turn ends up in the roundhouse.

Thanks,
The Duke