News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - snoopytoo

#1
HO / Re: Programming Problem
April 21, 2013, 11:18:57 PM
Ooops!  Knew I forgot something.

My system is Digitrax Chief.
#2
HO / Programming Problem
April 21, 2013, 08:42:00 PM
Just bought a Spectrum Climax, DCC & Sound.  Cannot change the decoder address.   When I attempt to change the address, the message on the throttle said "no d" the engine still ran only when the throttle was set to locomotive #03.  I have tried all four programming modes without success.  I can change other CV's. 

Need some suggestions on programming a new address.
#3
HO / Re: Alco 260 sound value decoder run awy
December 16, 2012, 12:44:18 AM
Thanks, Tom but, I had already tried that and it didn't work.  So, I tried again, still didn't work.  Kept at it and finally, for some unknow reason, the loco was back to normal.  One of those DCC gremlins, I guess.  I wish I could list everything I did but, alas, it's not to be.
#4
HO / Alco 260 sound value decoder run awy
December 15, 2012, 04:22:23 PM
My new Alco 260, with sound value decoder, runs at full speed - always!  Worked OK last week when I bought it.  Worked OK last week when I programmed the decoder.  Originally I programmed CV29 = 34, CV3&4 = 2 and address 46.  Worked OK after it was programmed orignally.  Today, I dialed in the address and it took off at full speed.  I had no control.  So, I reprogrammed CV29 = 38 and tried it on my DC test track.  Same thing, full speed.  One more thing, I also tried programming the address as a 2 digit address - same result.  Anybody have a suggestion?