I received the turnout new on bubble and card, with a supplied controller.
When tested with this controller, in any position of it, when the AC is connected, the motor buzz without any move of the rails and gets very hot, unless I cut the AC.
I tried with an other controller I had, in this case the motor goes only one way.

I asked the Bachmann service if it is possible to buy a new printed circuit for the faulty controller and a switch motor.
No reply.

Can someone help me?
Thanks in advance. J.B.

How many packs (of six) do I need to have a full circle?
Thanks, J.B.

Yes, I have studied the diagram and found no other screw than 10367 holding the body to the floor.No one has tempted to install a decoder ?

I have bought the nice Class J of N&W in freight version with 2 tenders ref 82015.
It is said DCC ready. So I wish to put a decoder in it.
I am unable to access to the IC board because I cannot separate the tender body from the floor. Even with the four locks open and the central screw through the floor unlatch, I cannot separate the floor.
Can some one help me?
For those who wish to have a floor picture I am only able to send to an URL.

Thanks in advance