News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - restorer

#1
General Discussion / remove shell from new bachmann gp40
December 12, 2016, 09:03:42 PM
How to remove shell on Bachmann MKT GP40  #63519.  Just got it and want to install DCC.  Does the fuel tank come off first, and the shell pulls off, Thanks.   Restorer
#2
General Discussion / mantua dcc instalation
December 07, 2016, 07:14:40 PM
any advise on a dcc decoder on the mantu HO U ARMY GP20 #414009.    it"s dcc ready.    Thanks
#3
General Discussion / bachmann ho gp40 dcc decoder
November 26, 2016, 02:20:19 PM
looking for a  dcc decoder (NOT SOUND) for Bachmann emd gp40 .  It's a Ho (miss. kan.tx.) #63519. The web site shows it has a factory installed 8 pin plug.   I'v checked Digitract with no luck so far.  Thanks
#4
General Discussion / rs3 sound installation
August 06, 2015, 04:16:57 PM
I'm interested in Bachmann rs-3 dcc installed..  Any suggestions on what steps to take on installing sound.    Thanks in advance
#5
I recently received a 2-6-6-2 Spectrum dcc (no sound).  I have a Digitrax Zephyr DSC51 controller.  I like to increase the speed, as this engine runs slower than I would like.  I ran other steam engine and they ae doing fine.  Thanks for any help.   Restorer
#6
HO / 3 and 5 pole motors for 2-8-0
October 23, 2013, 05:12:37 PM
I received some suggestions on purchasing 2-8-0 spectrum vs. the standard line, but how can you tell how many poles are in the engine without disassembly.  Where are these located and the purpose.   I have the spec sheet for an 2-10-2 spectrum and it shows an ass-motor. Is that one.   Thanks----Restorer
#7
HO / spectrum Southern 2-8-0
October 22, 2013, 02:08:44 PM
A local dealer has an unopened spectrum Southern 2-8-0 (non DCC). It 's close to the  the same price as the standard line (with DCC) on the internet.  I can install the DCC on the spectrum.  Any thoughts on the best choice.   The Dcc would run about $30.00 plus.  Thanks
#8
General Discussion / dcc controller for diesel locomotive
December 15, 2012, 10:36:56 PM
can the photo 2000 diesel emd f7a-b 920-40605  have a dcc decoder install and where do I get the decoder