I want to say thanks for all the help and advice. I took the track apart and cleaned and made sure all the connections were connected and found that i had a short in the track from them not be connected right. Once again thanks to all of you for the help.

Ok I will add a second feeder to the layout and see if that works thanks.

I am using a Kato transformer, and yes they seem to stall out at the same spot on the track in a curve sections. I have cleaned the track. I think that the transformer may not support the locos since i have two tracks and it does the same with both. thanks

I cleaned the track, I dont run both dc and dcc at the same time only one at a time I have two tracks and run two power packs.  I run a bachmann F7A and B units dcc ready, a alco RS-3 DCC on board and a Baldwin 4-6-0 Dcc ready, My Kato locos are Ge44-9w and are dcc ready they have no problem running.

I run dc track and only one dc train at a time

The problem i am having is that when the locos run around the track they just stop loose power. I run one DCC and two dc locos. The all start out fine just when the get going the stall out.

I am having trouble with my Bachmann N scale locomotives running on kato unitrack. I have Kato locomotives that run fine, what could be the reason for the bachmann not to run?

Can some help me out? I'm trying to take the shell of a EMD GP 40 locomotive to make it a dummy and need help?

I'm looking to due a n scale passanger train layout, my question is what is the minimum curve radius i can use?

When ordering a complete slope tender for 0-6-0 does it come blank or can you order it with decals?

thanks which decoder did you use?

Can you put a decoder in a old time 4-4-0 loc.?

I am looking for a truck for a atsf tender.