News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - 130MM

#1
HO / Setting Motor Control Values
October 14, 2009, 04:23:49 PM
I recently tried to use NCE's PowerCab to match loco speeds of a Bachmann SD-45 to other locomotives. I changed the value for the starting voltage, mid voltage and max voltage. But no matter what I set them to, the loco would start to move at the exact same throttle setting. I did check to see if the entered values had been saved, and they had. I went so far to set the starting voltage to 245, the mid voltage to 250 and the max voltage to 255 to see if anything different happened. But the loco moved at the same throttle setting. Also set them to 10, 20 and 30 with no change.

Any suggestions?