I have a Baldwin 4-6-0 that currently runs DC only. What type of non-sound decoder would be easiest to install?
Bill
Bill
- Welcome to Bachmann Online Forum.
News:
Please read the Forum Code of Conduct >>Click Here <<
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
On30 / Problem replacing the gears
December 09, 2013, 06:20:57 PM
I am replacing the drive shaft on my Shay and have run into an issue.
I followed the pictoral on the Railroad Line Forums showing how to release the clips. On the
back side of the clips, I only see two holes with no prongs to press in to release the clip. I have pushed
into the holes with no luck of releasing anything.
Has anyone run into this issue? Any suggestions?
THanks,
Bill
I followed the pictoral on the Railroad Line Forums showing how to release the clips. On the
back side of the clips, I only see two holes with no prongs to press in to release the clip. I have pushed
into the holes with no luck of releasing anything.
Has anyone run into this issue? Any suggestions?
THanks,
Bill
#3
On30 / 4-6-0 won't run
November 14, 2013, 03:47:43 PM
I just received a brand new On30 4-6-0 from a dealer on Ebay today. The lights and sound works fine when I use Channel 03, but no movement at all! I have a Digitrax DCC system and other locos run fine.
Anyone have this problem? Any thoughts on what to do before I send it back?
Bill
Anyone have this problem? Any thoughts on what to do before I send it back?
Bill
Pages1