Just bought a SD45 spectrum DCC ready,( n scale) opened it up to install a chip and i have no idea of what hole in pc board is what.( #1-#8) Where can i find the info ,not with loco and have`t found it on the board.  Thanks Joe

 I know this is the Bachmann board but cant find the answer anywhere else. Does anyone know of a problem with Kato f3s when using a Digitrax dn163kob decorder that will cause them to stop running after 5 or 10 min? I have a ABA set for the CA Zepher that runs fine then any one of the engines just stops running, ture it off for 10 or 15 mins and they will run again until the next one drops out. Any help appreacated. Thanks
                                                                             Joe

 Does any one know if the old style turnout control switch ( #7563 ) is still avabile(sp)? This is before EZ Track. Am looking for 35 of them. Thank you in advance.   Joe

 Hello all of you brains, i have a question for you. I am installing new decorders in 2 new N scale ER Sharks using oem circuit boards, here is the problem on the test track the engine will operate correctly using address #3(default) but put engine on the main tracks and it will not operate at all on DCC but will operate on dc if you short rails together but can not control it as it runs full speed,put back on test track and it works fine. All other engines operate correctly on all adresses including #3. Test track is running a Digatrak Zepher and the main tracks are running a Digatrak DCS150 with a DT400. The decorders are MRC AD330 purchaced new. Any help would be apprecated.  Joe

 Was the Ca Zefpher ever pulled by steam or was it always diesel powered? If steam was used what type was used?
   Thanks in advance   Joe

 What is the posabilty of Bachman putting out a new series of the UP DD40AX? Or maybe being able to get new axel sets and /or new axel gears in N scale?
                                                          Joe

 Hello all;
I have a question reguarding Dcc, has any one ran a siding or spur off of a reversing loop before and if so any problems in doing so? Would be nice to be able to run a siding thru my industrial section of town.
                                                                        Thanks in advance   Joe

 About how long is normal turn around time on steam repair? Also what is normal check holding time ( been a month ). Thanks  Jbustle742

 Just a question on service, called bachmann repair and got recording saying to send in $15 and engine for service and repair on 4-8-4 Northern how long do they keep your check before cashing it? Been a month. What kind of turn around time are we talking about here?
                                                                  Thanks in advance Joe