Just got Dynamis ProBox with two extra receivers. System worked fine before. Now when I turn on Command
Station (with ProBox & receiver extension) then handheld, get great signal (all bars) as soon as I press "stop" button all sounds & lights on trains fire off but signal goes TOTALLY away that I can't run any trains, send commands (horns, bells, lites, etc.). Posted this on general discussion board and had suggestions as to low ac house voltage, bad engine reacting with Dynamis -- tried them all and, yes, battries in hand held brand new and
went back to old system w/o ProBox and same issue that worked ok b4. Dynamis, probox, two 5 amp power boosters (all Bachmann). For further info, I and another contributor have questions and issues under General Discussion titled ProBox with 5 amp booster. I might add, it does seem everytime I fire up the system (ProBox) it goes into auto synchronizing mode as described in IM; I make sure it does it's thing before starting, still have my locos on handheld as I do "cancel" to sync ProBox to my 1 handheld and as above, no change when I disconnect ProBox and go back to original Dynamis system. ANYONE??? MR. BACHMANN??

Will the 36509 receiver work/receive ok if mounted upside down? Since it's infrared, I assume orientaion is not critical. Have a unique situation and upside down on the wall would be much more convienient! THANKS

Fired up my ceiling layout after cleaning all track, etc and, as has occurred in past, have to be within a couple
feet of Dynamis receiver to maintain signal. Otherwise shuts down and can't even reset with "stop" button which has signaled a loss. Batteries in xmtr new and strong, receiver about 3 feet off floor, handheld 4 to 6 feet off
floor, especially when I'm on ladder checking progress! Always in line with receiver. Any suggestions or pack it
up and send to Bachmann for check out so I can get back for holiday visitors!! THANKS

Recently found that when I activate system (receiver on, transmitter then on, press "stop" button) the two do not communicdate and the system will not start up. Batteries fresh (and no low battery icon), close to receiver (3 feet) ID's matched at 0;
anyone out there in Bachland run into this/have suggestions? When I do get it running it often will not restart if I have to press the stop button. HELP!! and THANKS! PS-also show no signal strength on transmitter when this occurs.

Has anyone had any experience as to the range of the Dynamis IR system? I seem to be able to get not much more than 6 to 8 feet away before it loses signal. I've tried the receiver/command center from 3ft to 5ft high, tilted it and the line of sight is not more than 30degrees offset from controller to receiver. Low battery indicator not on, but I tested them anyway and are OK. THANKS!!

Have Dynamis running with 5 amp booster but overload trips regularily and often won't reset until a several hour "cool down". Running ABBA F7's, double headed steamers,
SD45/GP38 consist, (all with sound) 18 lighted passenger cars and about 10 GOW bulbs. Any suggestions without going to power districts? It would be extremely labor intensive
as I have a main bus with feeds every 4 feet to two tracks which run about 7 ft off the floor
around the walls of my living room. THANKS ANYONE!!

Just got Dynamis--already have Bachmann 5 amp booster and just want verify hook up with someone in the "know"!! Nothing in the manual but I presume same as EZ Command--out to track on controller to DCC in on booster--I sure don't want to "fry" anything!!

Hi train fans--what's the word on the Dynamis system?? Guess it just became available in the U.S.. Anyone out there used it??? What's the word?