I have a brand new dynamis unit and started using it to address my engines about 2 days ago
I finally mastered the art of programing and on the third engine I turned the handset off and back on and the screen is frozen on the overview screen and the command station is blinking the lefthand green led.
i unplugged the power line and the track line, changed the batteries and there is no change.
what happened? is this a know problem or is the unit dead? less than 3 hours on the unit while figuring out how to program.   

I have a new dynamis unit and the instructions are about as clear as mud
Is there any other place to get step by step instructions on how to use this unit?

I just purchased 2 Bachmann steam engines
A 4-4-0 Union Pacific and a 4-4-0 Central Pacific Jupiter
Has anyone installed a decoder in them/
Did you have any Problems and what decoder did you use?

Will the 5amp booster and the dynamis controller work together and are there any drawbacks using them together?

Is it possible to use 2 or 3 digit addresses in the ez command?

Where can I buy or find a wiring diagram for the EZ command connection wires?
I also need a cable to tie my dc to dcc together.

I am using older HO track that's about 40 years old and after a good cleaning I find that the connectors are quite loose causing poor contact between the track sections.
I didn't want to solder each section so I thought of away to make a semi permanent way to solve this problem.
I use wire glue to help solder solar cells together so why not paint the outside rail joiners with the wire glue to make the electrical connection?
Let me know your thoughts on this please.