Hello Everyone i have not posted for a while hope everyone is well i am looking for a 49MHZ Transmitter for a 90101 R/C ATSF Loco i have just acquired if you can help it will be most appreciated thanks Greg.

Hello can someone tell me what colour wires are for the front light on this loco I have wired up the decoder and need to connect the headlight wires to the decoder the decoder instructions say blue and white but when I remove the light from the boiler the leads are black and red thanks Greg.

Hi everyone I need some help has anyone done this installation I cant get chuff to work have stripped out std board and connected as per instructions my board is the one you use with chuff timers any ideas thanks Greg.

Hello everyone can someone tell me where to connect speaker wires to in the tender of a 4-4-0 I am installing a decoder amd sound  I can see the wires coming from the brass strips do you connect to these thanks Greg.

Hello everyone I have a  3 truck shay with factory sound brand new I have put it on the track controller is a Bachmann Ezy Command powered by a 10amp 24 volt power supply I have the power supply set at 14volts but have also tried 18volts the decoder works eg sound comes out, the fire box flickers and the headlight comes on but the loco wont move in either direction have tried the front switch both ways still no movement there is no motor noise at all any ideas before I pull it apart have tried three different addresses with no luck thanks Greg.

Hello I need some help can I run my 3 truck shay with factory dcc and sound on dc I have a Crest 10amp controller part number 55401 with a variable power pack which gives me up to 24 volts the Aristo controller has pulse width control Aristo states it is different to pulse power will it damage the dcc or sound unit if run at around 18 volts or less thanks Greg.

Hello I have a few questions re my new 4-4-0 sorry if this has been covered before. 1) Is the front light glued on mine is loose press fit and just pulls off also the base of the smoke stack is not glued on and just pulls off this is a new loco straight out of the box. 2) Is there name bars available for the loco and decals for the tender as mine is unlettered.3) What coupler can I fit to tender to pull Aristo Sierra coaches this is a really nice loco thanks Greg.

Hello to everyone I am a newbie from Brisbane Australia, hope someone can help I recieved a new but damaged 2-6-0 Mogul from a US dealer I have decided to keep this loco after much discussion after cleaning I put it on the track it will not move foward or back just sits there making a loud clicking noise and revving, it rolls freely when you push it by hand and the side rods move. the ash pan also lights up any ideas and help would be great it is part number #81498 thanks Greg.