On my Layout, I have a manual switch to change control between a Bachmann EZ controller vs a JMRI/SPROG II PC setup. Things are working about 80%, but I have two issues I am still working on.

1.  Bachmann EZ controller F10 controls Bachmann loco lights on/off.  I cannot get any of the F0-F24 function buttons on the JMRI/SPROG III throttle to control these lights.  Anyone know a workaround for this?  What is the Bachmann EZ controller actually sending for the F10 function?  I have read it is F0, but that still does not work in the PC environment. 

2.  Bachmann DCC turnouts.  I have seen a couple of conversations on this one and am hoping someone has come up with a work around.  I can program the turnouts via the Bachmann EZ controller and they work with that system.  I can also program the turnouts via PanelPRO JMRI/SPROG III and they work with that system.  Problem is once programed in one system, the other system can not see them on any address...  And vice versa.  I know this in the Bachmann DCC turnout documentation, but as i said, I am hoping someone has figured out a work around.

Thanks for any help on these!

Rob

I am new to DCC and have several Bachmann DCC turnouts that I am trying to program and run using a SPROG III with JMRI.  Anyone have instructions on how to do this?

thanks

Rob