I installed a new TSC KA 4 in my 4-6-0 as per instructions  and it works great...my problem is...I don't have a headlight now....I saw a video somewhere that I should ( I think) clip one lead on the yellow horse shoe looking resistor (?)(I'm not a electronics expert) on the BACHMAN BOARD. Did I remember right? Thanks in advance....BREEZY8

I have a SPECTRUM 4-8-2 LT MTN. with  SOUND TRAXX ECONOMI 100 DECODER installed.  when I fie it up , it idels just fine. add throttle , 1, or 2 notches and it goes JERKEY. IT WILL MOVE 1", LIGHTS GO OUT,sound goes off and then it will start moving again..sometimes 3"s,some times more, sometimes less... then it goes JERKEY again. Track is clean, wheels too. When I first installed the decoder, It ran just fine, and has until recently . Any ideas?   I don't have much hair left to pull...LOL..  BREEZY8

I have a SPECTRUM 4-8-2 and it seems that the WORM GEAR and the DRIVER GEAR are NOT making contact.....Decoder works fine, but it is FREE WHEELING ( no gear contact) I can turn the drivers easily. Any ideas as to a solution to this?  Any help would be GREAT....TONY  AKA breezy8

I HAVE A HO  4-8-2 LT MTN loco Item # 81601, that after running a while,it just stops moving.  The DCC decoder still works(sound) but it trys to move( with finger push) about an inch , then stops again, and repeats, ect, ect, ect..... It is like the gear is slipping on the shaft or something...Any ideas?  I was pulling 11 cars on a FREE MO layout.  not a big load....Any help would be great....BREEZY8

   I just bought a spectrum 4-6-0 and was wondering.....I want to install a soundtraxx economi decoder and speaker......My question is...where is the best place to mount these.?  There is room in the tender for the decoder, but I am running out of room for a speaker really fast....and if you can, what speaker would you recommend?....Many thanks....breezy8

What is the proper way to wire a 3mm LED to the headlight on a LT MTN 4-8-2 It is now set up and runs on DCC. It has the board in the tender and I added w/ 8 pin plug a Sound traxx ECONOMI DECODER.  after so fiddleing, it runs great. .Now  I need to add a LED headlight...Thanks so much   breezy8

I just received a replacement (under warrentee) of a 4-8-2- Lt mountain. I added a soundtraxx "economi" sound decoder and it works great ( the decoder)...My question is:  on speed steps 1-2-3  the engine JERKS wildly...I have to get to speed step 4 and above for it to run smooth ( NO JERKING)..   HOW DO I CORRECT THIS..?...Thanks in advance....TONY

What is the location of PIN #1 on the 8 pin socket on the board in the tender of a 4-8-2 lt  Mtn, Part # 81601.  Most boards have it marked, this one doesn't.. Thanks in advance...breezy8

Are there instructions on how to disassemble a SPECTRUM USRA LIGHT MOUNTAIN 4-8-2, Item #81601